Description
EFLA1040LB E-Flite 40-Amp Lite Pro Switch-Mode BEC Brushless ESC (V2)
Note: Graves RC Coupons are not applicable with this product
The E-flite 40-Amp Lite Pro Switch-Mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.
Features:
- Up to 40 amps continuous current with proper air flow and 55 amps burst current (15 seconds)
- 5A continuous current, 5V Switch-Mode BEC Circuit (Proper cooling and airflow required)
- Stronger BEC for support of most 3-axis stabilization systems
- Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage
- 3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
- Programmable motor braking
- Safe power-arm mode prevents accidental starts
- Programmable low voltage cutoff with settings for 3-cell Li-Po (9.2V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
- Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms)
- Programmable soft start for helis and airplanes
- Auto motor shut down if signal is lost or there is interference
- Programmable timing—5 user-selectable ranges, use with a large variety of brushless motors
Specifications:
Amperage: | 40-60 |
---|---|
BEC Voltage: | 2.5A continuous |
Brake: | Yes |
Continuous Maximum Current: | 25 - 50A |
Height: | 0.47 in (12mm) |
Input Connector Types: | 13 AWG with E-flite EC3 Connector |
Input Voltage: | 3S-6S LiPo or 9- to 18-cell Ni-MH/Ni-Cd |
Length: | 2.6 in (66mm) |
Momentary Peak Current: | 55A |
Output Connector Types: | 16AWG with 3.5mm Female Gold Bullet Connectors |
Type: | Brushless |
Weight: | 1.7 oz (48g) |
Width: | 1.2 in (31mm) |
Additional Information
ESC Max Amps: |
40A to 59A |
ESC Max Voltage: |
14.8V to 22.1V |
ESCs & BECs: |
BEC |