Description
HITHSD954SW Hitec D954SW Standard Digital High Torque Steel Gear Servo
Features
- Coreless metal brush motor
- Programmable PWM Digital Amplifier
- 32-Bit MCU with 12-Bit ADC circuitry
- End Point Adjustments
- Direction
- Fail Safe
- Dead Band
- Speed (slower)
- Soft Start Rate
- Overload Protection
- Data Save/Load
- Program Reset
- 4096 resolution
- Nylon reinforced plastic upper and lower case with aluminum heat sink center case
- Dust resistant and splash proof
- Dual ball bearing supported output shaft
- 1M cycle long life potentiometer
In The Box
- D954SW Servo
- 1.7" (44mm) long Double Arm
- 1.69" (43mm) 4-Point Horn
- 1.4" (36mm) diameter Round Horn
- 1.04" (26.5mm) Single Arm Horn
- 3mm Horn Screw, & Hex Socket Screw
- Four each Grommets, Eyelets and Mounting Screws
Specifications:
| Application | 30-40% sport planes, 2 meter+ sailpanes, 30-40% 3D & performance scale aircraft, all 1:8 scale vehicles, 1M & scale sailboats |
| Bearing | Dual |
| Bushing Or Bearing | Bearing |
| Current Draw Idle | 30mA |
| Current Draw Stall | 5,200mA |
| Deadband | width, 1?s |
| Maximum Servo Speed | 0.100-0.149 sec |
| Maximum Servo Torque | 350-499 oz-in |
| Motor Type | Coreless, metal brushes |
| Product Height | 1.46" (37mm) |
| Product Length | 1.57 in (40mm) |
| Product Weight | 2.40 oz (68g) |
| Product Width | 0.78 in (20mm) |
| Programmable | Yes |
| Servo Operating Voltage | 4.8 - 8.4V (HV) |
| Servo Size Category | Standard |
| Servo Type | Digital |
| Spline Count | 25 Teeth |
| Wire Gauge | 20 AWG |
Additional Information
Max Voltage: |
7.4v |
Min Voltage: |
4.8v |
Gear Material: |
Steel |
Motor: |
Coreless |
Size: |
Standard |
Speed 4.8V: |
0.10 sec/60° - 0.19 sec/60° |
Speed 7.4V: |
0.10 sec/60° - 0.19 sec/60° |
Torque 4.8V: |
More Than 200 oz - in |
Torque 7.4V: |
More Than 200 oz - in |
Weight: |
2 - 2.49 oz |
